Subject: oops - that's a 350
Name:
Joe F Date: 1/16/2002 6:52:45 AM (GMT-7)
IP Address: 65.29.232.126 In Reply to: Socket 7 troubles... posted by
Joe F Message:
K6-2 350
The most I get from the board is a single short beep every few seconds. I tried 2 x 32 SIMMs at 66 MHz, and I tried a stick of PC133 at 66 MHz. Even with no RAM I get the same beep. I tried the jumper settings from the manual (as near as I could decipher them), and I tried the jumper settings listed in the FAQ in FIC's site for a 350 w/ 66 MHz RAM and also for a 266 w/ 66 MHz RAM.
Also tried both AT & ATX power (I did make sure the jumper was set for the proper power supply), different vid cards (2 old PCI cards, but the only AGP I had handy to test was my GF3), and striping down to CPU, RAM, video, and floppy. Also cleared the CMOS a few times.
I even tried a P133 chip with 66 bus, 66 RAM, multi 2X, and using the setting for 3.3 Vcore from the FAQ. Didn't even get the beeps then.
|