Subject: Will my 1.0AGP G2oo fit the new mobos?
Name:
Celstk855 Date: 10/18/2001 2:08:19 PM (GMT-7)
IP Address: 210.84.108.73 Message:
Below is a thread I picked up at my Matrox Forum...
----------------------------------------------
Wombat
Super MURCer
Registered: Aug 2000
Location: Ft. Collins, CO
Posts: 1318
I don't think it will work. G200's are AGP 1.0 only, and it sounds like i850 boards are AGP 2.0 only. (This is NOT the same as AGP1x and AGP 2x).
__________________
Epox 8KTA3 w/ Duron 850@7.5*133 with Alpha 6035, 256MB Crucial 7E, G400MAX,SBLive!-MP3,Pioneer 10x DVD, Plextor 12/10/32A, IBM 45GB 75gxp, and a Sony 420GS. Running RH7.0 (2.4.5), and Win98SE (when I have to).
Report this post to a moderator | IP: Logged
14th October 2001 22:36
LvR
MURCer
Registered: Jun 2000
Location: South Africa
Posts: 198
If you are willing to do some serious modifications:
Check out a standard 4X cards edge connector - you will find a key-slot roughly an inch from the front of the card that is absent on the Mill 200 and is mechanically preventing it from fitting.
Go find yourself a microgrinder and machine an identical slot on the Mill 200 in the identical position on the card.
Plug in, load the drivers and there you go!
I have 4 of these modded cards running on 845 and 850 based boards because the customer insisted on re-using these cards.
----------------------------------------------
Is this an interesting concept - am I unduly worried
|